7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Appendix: 7210 SAS boot
procedures
Example
No eth-mgmt IPv6 Address configured
You specified network locations which might require
static routes to reach. You will be asked to
enter static routes until all the locations become
reachable.
Static routes should be entered in the following format:
prefix/mask next-hop ip-address
example: 192.168.0.0/16 next-hop 192.168.1.254
A static route to the Primary Image exists: 192.0.0.0/8 next-hop 10.135.25.1
Do you want to keep it? (yes/no)
Step 13.
At the prompt, enter no. The following console output is displayed.
Example
Enter route to Primary Image at 192.254.173.3:
Step 14. At the prompt, enter the static route for the specified primary image location. The following
console output is displayed.
Example
A static route to the Primary Config exists: 192.0.0.0/8 next-hop 10.135.25.1
Do you want to keep it? (yes/no)
Step 15.
At the prompt, enter yes. The following console output is displayed.
Example
Enter route to Primary Config at 192.254.173.3 192.0.0.0/8 next-hop 10.135.25.1
Step 16. At the prompt, enter a static route for the specified primary configuration location. The following
console output is displayed.
Example
Would you like to add a static route? (yes/no)
Step 17.
At the prompt, enter yes. The following console output is displayed.
Example
Enter ip route:
Step 18. At the prompt, enter a static route to the FTP server subnet (for example, 10.10.170.0/10 next-
hop 10.135.4.1). The following console output is displayed.
Example
Would you like to add another static route? (yes/no)
Step 19.
At the prompt, enter no. The following console output is displayed.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
695
SPACER TEXT
To Next Page
Loading...