7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Appendix: 7210 SAS boot
procedures
Example
Would you like to add another static IPv6 route?
Step 20.
At the prompt, enter no. The following console output is displayed.
Example
Existing uplinkA port settings are:
uplinkA-port 1/1/65
no uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 100000
uplinkA-address 0
uplinkA-address 0
uplinkA-vlan 0
uplinkA port is configured for Boot Interface Management,
Press ENTER to proceed with existing port settings
Or "disable" to disable the port for Boot Interface Management
Or "edit" to change the port settings:
Step 21.
At the prompt, enter disable to proceed with no backup link. The following console output is
displayed.
Example
Existing uplinkB port settings are:
uplinkB-port 1/1/66
no uplinkB-autoneg
uplinkB-duplex full
uplinkB-speed 100000
uplinkB-address 0
uplinkB-address 0
uplinkB-vlan 0
uplinkB port is configured for Boot Interface Management,
Press ENTER to proceed with existing port settings
Or "disable" to disable the port for Boot Interface Management
Or "edit" to change the port settings:
Step 22.
At the prompt, enter disable to proceed with no backup link. The following console output is
displayed.
Example
Current configuration enables use of console (setting is "no console-disabled")
Press ENTER to proceed with existing setting or 'disable' to disable console access
:
Step 23. At the prompt, press Enter. The following console output is displayed.
Example
New Settings
------------
primary-image ftp://*:*@192.254.173.3/tmp/sass/b/both.tim
primary-config ftp://*:*@192.254.173.3/tmp/sass/sassx64.cfg
#eth-mgmt Port Settings:
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
696
SPACER TEXT
To Next Page
Loading...