Nokia 7210 SAS-Mxp - Page 703

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Appendix: 7210 SAS boot
procedures
Example
*A:dut-h# show system port-topology
===============================================================================
Port Topology
===============================================================================
Port Far-end
Id Port Id
-------------------------------------------------------------------------------
esat-1/1/c65/u1 1/1/1
-------------------------------------------------------------------------------
No. of Number of port-topology associations: 1
===============================================================================
c. Issue the show system satellite command to display the status of the satellite. The following
output is displayed.
Example
*A:dut-h# show system satellite
===============================================================================
Satellite Information
===============================================================================
SatID Provisioned Type Admin Oper
Equipped Type (if different) State State
-------------------------------------------------------------------------------
esat-1 es64-10gb-sfpp+4-100gb-qsfp28 up provisioned
(not equipped)
-------------------------------------------------------------------------------
No. of Satellites: 1
===============================================================================
*A:dut-h#
Step 4. Power on the Ethernet satellite:
a. Power on the 7210 SAS device.
The satellite will use the bootloader on the SD card inserted in cf2:\ (SD card slot on the rear
of the chassis) and initiate the boot procedure.
The 7210 SAS device sends DHCP requests out of its uplink ports.
The 7750 SR host uses the MAC address in the received packets and matches it against
MAC addresses provided in the Ethernet satellite configuration on the 7750 SR host.
After finding a match, the 7750 SR host uses the configured image and an appropriate
configuration file, generates a BOF, and sends it to the system (the host-type parameter in
the BOF generated by the 7750 SR host is set to satellite).
The 7210 SAS boot loader uses the BOF to retrieve the images and the configuration file,
and uses them to boot the platform in the satellite mode (because the host-type is set to
satellite).
The satellite transitions through the following states: provisioned, booting, and up.
b. Issue the show system satellite command to determine the boot status of the satellite. The
following output is displayed.
Example
*A:dut-h# show system satellite
===============================================================================
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
703
SPACER TEXT