Nokia 7210 SAS-Mxp - Page 711

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Appendix: 7210 SAS boot
procedures
Example
You need to assign an IP address for this port.
The IP address should be entered in standard
dotted-decimal form with a network length.
example: 192.168.1.169/24
Enter eth-mgmt Active IP Address :
Step 22. At the prompt, enter the active port IP address and mask that the device should use (for example,
10.135.4.172/10). The following console output is displayed.
Example
In case of an IPv6, the IPv6 address should be
entered in standard colon hexadecimal notation
with a prefix length.
example: 3FFE::1/112
Enter eth-mgmt Active IPv6 Address (Type 0 if none desired):
Step 23. At the prompt, enter 0. The following console output is displayed.
Example
Enter eth-mgmt Standby IP Address (Type 0 if none desired):
Step 24. At the prompt, enter the standby port IP address and mask that the device should use. The
following output is displayed.
Example
In case of an IPv6, the IPv6 address should be
entered in standard colon hexadecimal notation
with a prefix length.
example: 3FFE::1/112
Enter eth-mgmt Standby IPv6 Address (Type 0 if none desired):
Step 25. At the prompt, enter 0. The following output is displayed.
Example
You specified network locations which might require
static routes to reach. You will be asked to
enter static routes until all the locations become
reachable.
Static routes should be entered in the following format:
prefix/mask next-hop ip-address
example: 192.168.0.0/16 next-hop 192.168.1.254
Would you like to add a static route? (yes/no)
Step 26.
At the prompt, enter yes. The following output is displayed.
Example
Enter ip route:
Step 27. At the prompt, enter the static IP route. The following output is displayed.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
711
SPACER TEXT