7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Appendix: 7210 SAS boot
procedures
Example
OK
Would you like to add another static route? (yes/no)
Step 28.
At the prompt, enter no. The following output is displayed.
Example
Would you like to add another static IPv6 route? (yes/no)
Step 29.
At the prompt, enter no. The following console output is displayed.
Example
Current configuration enables use of console (setting is "no console-disabled")
Press ENTER to proceed with existing setting or 'disable' to disable console access
:
Step 30. At the prompt, press Enter. The following console output is displayed.
Example
New Settings
------------
primary-image ftp://*:*@10.135.24.85/./img/sass/both.tim
primary-config ftp://*:*@10.135.24.85/./cfg/sass/dutE_vcCfg.txt
#eth-mgmt Port Settings:
no eth-mgmt-disabled
eth-mgmt-address 10.135.24.94/24 active
eth-mgmt-address 10.135.24.95/24 standby
eth-mgmt-route 135.0.0.0/8 next-hop 10.135.24.1
eth-mgmt-autoneg
eth-mgmt-duplex full
eth-mgmt-speed 100
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
vc-stack-name VC123
vc-stack-node-type cpm-imm
vc-stack-node cpmA slot-num 1 mac-addr d0:99:d5:9a:6a:41
vc-stack-node cpmB slot-num 2 mac-addr d0:99:d5:94:de:41
Do you want to overwrite cf1:/bof.cfg with the new settings? (yes/no):
Step 31.
At the prompt, enter yes. The 7210 SAS device begins to boot with the new settings. The
following console output is displayed.
Example
Successfully saved the new settings in cf1:/bof.cfg
******************* VC Mode ********************
Configuring Network with eth-mgmt Port Setting.....
Primary config file location: ftp://*:*@10.135.24.85/./cfg/sass/dutE_vcCfg.txt
Initial DNS resolving preference is ipv4-only
Downloading 'ftp://*:*@10.135.24.85/./cfg/sass/dutE_vcCfg.txt'...OK
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
712
SPACER TEXT
To Next Page
Loading...