Nokia 7210 SAS-Mxp - Page 79

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
CLI usage
Context
monitor>filter
monitor>management-access-filter
Platforms
Supported on all 7210 SAS platforms as described in this document, including those operating in access-
uplink mode
Description
This command enables IP filter monitoring. The statistical information for the specified IP filter entry is
displayed at the configured interval until the configured count is reached.
The first screen displays the current statistics related to the specified IP filter. The subsequent statistical
information listed for each interval is displayed as a delta to the previous screen output.
When the keyword rate is specified, the rate per second for each statistic is displayed instead of the delta.
Monitor commands are similar to show commands, but only statistical information is displayed. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters
ip-filter-id
Displays detailed information for the specified filter ID and its filter entries.
Values 1 to 65535
entry entry-id
Displays information on the specified filter entry ID for the specified filter ID only.
Values 1 to 65535
interval seconds
Specifies the interval for each display in seconds.
Default 5 seconds
Values 3 to 60
repeat repeat
Specifies how many times the command is repeated.
Default 10
Values 1 to 999
absolute
Keyword to display raw statistics, without processing. No calculations are performed on the
delta or rate statistics.
rate
Keyword to display the rate per second for each statistic instead of the delta.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
79
SPACER TEXT