DMTA-10022-01EN, Rev. C, January 2015
Software Options
91
It is possible to store approximately 475000 thickness values without waveforms in
the internal memory, or approximately 20000 thickness values with waveforms. You
can double the storage capacity by using an optional external microSD memory card.
The maximum capacity of the external microSD card that can be used on the 45MG is
2GB.
With the datalogger, you can easily create a data file (see “Creating a Data File” on
page 92), perform a number of file operations (see “Performing File Operations” on
page 105), and perform data operations (see “Setting the ID Overwrite Protection” on
page 115).
Table 6 Additional information stored with the data
For a measurement For a waveform
File name
File header data
Identifier
Units (mm or in.)
LOS (loss of signal)
Differential mode
Differential reference value
Alarm mode
Alarm status
Alarm set points
Minimum or maximum mode
Minimum or maximum reading
Velocity
Resolution
Transducer setup number and information
Coating thickness
(when THRU-COAT is active)
Zoom status
Horizontal axis limits
Detection marker position
Delay
Range
Rectification mode
To Next Page
Loading...
