Olympus 45MG - Table 15 Default Communication Settings

DMTA-10022-01EN, Rev. C, January 2015
Chapter 12 202
MASTER RESET
Performs the measurement reset and the internal memory reset in a single step.
The master reset permanently deletes all stored thickness readings/waveforms that
are stored in the internal memory card of the 45MG.
To activate a reset function
1. In the measurement screen, press [SETUP], and then select RESETS.
2. In the RESETS screen (see Figure 12-1 on page 203):
a) In the RESETS list, highlight the desired reset function.
A warning message appears, indicating the type of data that will be reset.
b) Select RESET.
Table 15 Default communication settings
Parameter Default value
COMM PROTOCOL MULTI CHAR
OUTPUT FORMAT F1
B-SCAN OUTPUT OFF
FTP OUTPUT 45MG
OUTPUT TYPE FTP
CAUTION