Olympus 45MG - Figure 11-1 Connecting the 45 MG to a Computer

DMTA-10022-01EN, Rev. C, January 2015
Chapter 11 188
For more information on installing GageView, refer to the GageView Interface Program
— User’s Manual (P/N: 910-259-EN [U8778347]).
2. If you use a communication program other than GageView, refer to the program
documentation for proper configuration of the program for USB communication.
3. Turn the 45MG on.
4. Connect one end of a USB cable to the USB client connector on the top of the
45MG, and connect the other end to a USB port of the computer (see Figure 11-1
on page 188).
Figure 11-1 Connecting the 45MG to a computer
The first time the 45MG is connected to this computer, the computer alerts you
that a new hardware device has been detected, and asks you if you want to install
the driver. Refer to the GageView Interface Program — User’s Manual (P/N: 910-259-
EN [U8778347]) for more information.
The driver loads, after which you can start using a program like GageView to
communicate with the 45MG.
NOTE
USB cable