Olympus 45MG - Sequential Data File Type; Table 8 Resulting ID Examples for the SEQUENTIAL File Type

DMTA-10022-01EN, Rev. C, January 2015
Chapter 6 96
6.7.2.3 Sequential Data File Type
The sequential data file type is similar to the incremental type, although it also allows
you to define both starting and ending ID numbers. The resulting file is inclusive of
the starting and ending points, and all incremental points in between (see the
examples in Table 8 on page 96).
To create a sequential data file
1. In the measurement screen, press [FILE], and then select CREATE (see “Creating
a Data File” on page 92 for details on the first parameters).
2. At the bottom of the CREATE screen, select CONTINUE.
3. In the second page of the CREATE screen (see Figure 6-19 on page 97):
a) Enter the START ID and END ID values.
b) Select CREATE.
Table 8 Resulting ID examples for the SEQUENTIAL file type
START ID END ID Resulting IDs
ABC123 ABC135
ABC123
ABC124
ABC125
...
ABC135
XY-GY XY-IB XY-GY
XY-GZ
XY-HA
...
XY-IB