DMTA-10022-01EN, Rev. C, January 2015
Chapter 2
30
Do not replace the batteries while the instrument is on. Dispose of used batteries
promptly. Keep batteries out of reach of children. The batteries used in this device
may present a risk of fire or chemical burn if mistreated. Do not disassemble, heat
above 50 °C, or incinerate the batteries.
To replace the batteries
1. Ensure that the power to the 45MG is turned off.
2. Disconnect any other cables connected to the 45MG.
3. Remove the optional protective rubber boot, if installed.
4. Turn the battery door lock half a turn counterclockwise to the unlock position.
5. Remove the battery compartment cover.
6. Remove the batteries.
7. Insert three new batteries in the battery compartment, making sure that you
observe the correct polarity.
8. Ensure that the gasket inside the battery compartment cover is clean and in good
condition.
9. Reinstall the battery compartment cover on the back of the instrument, push
down on the bottom of the battery door, and then turn the battery door lock half a
turn clockwise to the lock position.
10. Reinstall the optional protective rubber boot, if required.
11. Press to turn on the 45MG instrument.
12. To answer the question appearing at the bottom of the screen (see Figure 2-4 on
page 31):
Select Alkaline when using three AA-size alkaline batteries.
OR
Select NiMH when using three AA-size nickel-metal hydride (NiMH
batteries).
OR
Select Lithium when using three AA-size lithium batteries.
To Next Page
Loading...
