Defining the Properties of a Page SECTION 2 Pages
28
2-3 Defining the Properties of a Page
A page has certain attributes, or properties. These properties may be viewed
and edited in two ways. The simplest way to access the properties of a page is
to double click with the left mouse button in the background area of the page.
This causes CX-Supervisor to display the following Page Properties dialog
box:
The Page Properties dialog box allows the viewing and editing of various
attributes.
1, 2, 3… To set the Page Properties:
1. Enter a title for the page in the Page Title: field up to a maximum of 32
characters.
2. Add a description (if required) in the Page Description field.
3. Enter the co-ordinates for the top-left corner of the page in the Top and Left
field. This value must be in pixels, and must be a positive integer between
0 and 2000. Alternatively, click the Full Size button to fill the runtime
environment workspace.
4. Enter the height and width measurements for the page in the Height and
Width fields. These values must be in pixels, and must be a positive
integer between 0 and 2000. click the Centre button to centre the page to
the graphics workspace.
5. Select the border style for the page from the Border Style settings. The
default for this is Sizeable, as shown on the Page Properties dialog box.
Changing the selection will update the shown preview.
6. To prevent the title from being displayed, click the Display Title setting to
remove the check mark. The following change occurs in the dialog box:
To Next Page
Loading...
Need help?
General