Creating and Editing Control Objects SECTION 4 Objects
64
Configuration attributes can be altered by typing over the existing field entries.
The style attributes can be amended by clicking on the settings.
Exit the Axis Scaling dialog box by clicking the OK button to accept the
scaling attributes, or click the Cancel button to leave unchanged.
4-4-8 Slider
Sliders allow values associated with them to increase or decrease between
certain limits. They can also ensure that values do not exceed previously set
limits.
Click the button, then click or click and drag on the page to insert a slider.
To edit the Slider, double click on it. The Slider Wizard dialog box opens:
The Wizard allows entry of in the Slider Style:, Style Attributes: and
Configuration Attributes: fields. To select a style, click on an option from the list
box. The Style Attributes: can be either Display Vertical or Display Horizontal.
To select a Boolean point, click the Browse button and select a point from the
displayed list. Click the OK button to accept the point or click the Cancel
button to leave the point unselected. Clicking the Add Point button allows a
new point to be created prior to association with the Wizard. An existing point
can also be associated with the Wizard by dragging a point directly from the
Point Editor. Refer to chapter 3, Points regarding adding a new point and
dragging from the Point Editor.
Enter the maximum and minimum slider values and check the box to display
the minimum value at the left or bottom of the page.
To Next Page
Loading...
Need help?
General