Settings SECTION 6 Projects
97
6-10-2-9 Point Substitution Settings
The enclosing characters associated with a report can be changed via the
Point Substitution Settings dialog box. When set, these characters must be
fixed for all reports generated by the project. Select Runtime Settings from
the Projects menu, followed by Point Substitution Settings, the Point
Substitution Settings dialog box opens.
Supply enclosing characters in the Opening Characters: field and Closing
Characters: field. Click the OK button to accept the settings, or the Cancel
button to abort the operation.
6-10-2-10Advanced Settings
To open the Advanced Settings dialog box select Advanced Settings from the
Runtime Settings menu:
Click the settings to enable/disable Internal Communication Optimisations and
Communication 'Packet' Optimisations.
Bad Quality values, and results of calculations using bad quality values can be
shown as '#' characters. This could indicate a communication failure, or Bad
Quality status in an OPC Server.
If you may need to option to edit the PLC settings in the runtime without
recompiling in the developer then untick the "Embed CX-Server Project within
CX-Supervisor .SR2 file" option. This is useful for example if it is possible the
To Next Page
Loading...
Need help?
General