Chapter 6: Connectivity
The control power connector is fused with two separate 3 A resettable fuse connections.
Although the voltage of these connections are 24 VDC regulated, the voltage can vary from
23.8 VDC to 25.2 VDC. Loads connected to this output must be capable of withstanding this
voltage range.
NOTE: Since the control power connection is protected by resettable fuses, it is
the end user's responsibility to ensure that the over-current (including the in-
rush current) is kept below the noted thresholds. See: Power Limits on page 138.
Pin No. Designation Notes
1 Control Voltage
Connections to the Battery Control
2 Control Voltage
3 GND
4 GND
31500-000 Rev A HD-1500 Platform User's Manual 160
To Next Page
Loading...
