Omron HD-1500 Platform - Required Connections; Platform Required Connections

151 HD-1500 Platform User's Manual 31500-000 Rev A
6.1 Required Connections
Figure 6-2. User Access Panel
6.1 Required Connections
Platform Required Connections
l
Pendant port In order to generate maps with the platform, you need to connect a
pendant to the pendant port.
The pendant port is available on the Operator Panel, located on the
rear of the platform. See: Figure 6-4. .
This is internally connected to the AMR Controller in the electronics
bay.
Pendant
Figure 6-3. Operator Panel Located on the Rear of the AMR