Omron HD-1500 Platform - Safety Precautions

Chapter 2: Safety
!
WARNING: PERSONALINJURYORPROPERTYDAMAGERISK
You must route, and secure the power cord properly. It must be secured in
such a way that prevents straining of the connection points. There must be a
physical protection that prevents the tripping hazard and cable crushing.
If the power cord is laid on the ground, use a visible cover (e.g. yellow and black tripped
cover) that goes over the power cord, and prevents crushing of the power cord.
WARNING: HOT SURFACEHAZARD
The docking target charging contacts heat up during the charging process. Take
necessary precautions to avoid burn dangers.
Safety Precautions
Lock-out, Tag-out (LOTO)
Prior to any maintenance work on the charging station, you must perform Lock-Out, Tag-Out
(LOTO) procedure. For information on how to perform LOTO, see: Lock-Out, Tag-Out Pro-
cedure on page 216.
Decommissioning
Follow these steps to discontinue the operation of a power supply box, and remove it from ser-
vice:
1.
Cut power to the power supply box through the main disconnect switch. Turn the main
disconnect switch to off position.
Figure 2-14. Main Disconnect Switch in OFF Position (Horizontal Position)
2.
Verify that the AC power is disconnected from the power supply box. When there is no
AC supplied to the power supply box, the blue LED is off.
3.
Next, disconnect the facility power to the facility power cable. This will disconnect the
facility AC power to the electrician access box.
31500-000 Rev A HD-1500 Platform User's Manual 56