Omron HD-1500 Platform - Light Strips

243 HD-1500 Platform User's Manual 31500-000 Rev A
8.7 Replacing Non-Periodic Parts
shows graphic cast made into the LED mount plate that display the correct direction of
LED strip installation.
Also, make sure to begin routing the LED strip at the slot shown below so that the end
of the LED strip can be properly routed to the center.
Figure 8-33. Routing the LEDStrip at the Slot
10.
Reverse steps 6 to 1, and re-install the skin.
11.
Dispose of the old LED strip according to the local and national regulations concerning
electronic components.
Light Strips
Before you begin, press an E-Stop button and turn the HD-1500 off.
You require the following tools to replace the light strip:
l 3 mm hex wrench
l Adhesive
Follow these steps to replace the light strip:
1.
Unlatch the front or rear skin depending on which light strip you are replacing. Refer to
Removing and Installing Skins on page 253.
2.
Pull the skin away from the platform just enough so you can disconnect the LED con-
nector as shown in the following figure.