127 HD-1500 Platform User's Manual 31500-000 Rev A
4.1 Settings and Configuration
1.
Open a Web browser on the PC and enter https://192.254.10.15 as the URL.
2.
If prompted to accept security certificates, confirm that you accept them.
3.
Verify that the SetNetGo Web Interfaceopens.
Setting Up Wireless Ethernet
A single HD-1500 can operate without a wireless network. For example, if it is the sole AMR
in a workspace and it does not need to share the workspace with other AMRs. However, if you
have more than one AMR sharing the same workspace, you must manage them as a fleet.
Fleet management requires continuous wireless network access. For more information, see:
Fleet Manager, for Multi-AMR Coordination on page 268.
Before you configure wireless Ethernet on your HD-1500, contact your network administrator
to confirm the IP, radio, and security settings.
Use one of the following methods to access the SetNetGo Web Interface:
l
Use the SetNetGo tab in the MobilePlanner software. See: Fleet Operations Workspace Core
User's Manual (Cat. No. I635).
l
Open a Web browser on your PC and enter the URL: https://192.254.10.15, to connect dir-
ectly to the SetNetGo Web Interface on your HD-1500. This enables your network admin-
istrator to set up the network for you.
To Next Page
Loading...
