Chapter 8: Maintenance
1.
Grip the skin at the two recessed handles and lift the skin.
2.
Connect the rear light connector to its reciever on the skin.
Figure 8-54. Rear Light Cable Connected to the Skin
3.
Next, locate the alignment receivers on the chassis.
4.
Lift the skin's alignment pins onto the receivers in the chassis as shown in the fol-
lowing figure.
Figure 8-55. Rear Skin Pin Alignment
5.
Install the skin on to the chassis and ensure that it latches.
31500-000 Rev A HD-1500 Platform User's Manual 260
To Next Page
Loading...
