Omron HD-1500 Platform - Page 63

Chapter 3: Setup
with impact
driver
housing crate to the base pallet.
Screwdriver, or
hammer
1 Screwdriver, or the hammer is used to remove the metal clips
attaching the front panel to the housing crate.
Safety box cutter 1 The cutter is needed to cut the film wrapped around the HD-1500.
NOTE: Do not use an open-blade knife such as a wall-
board knife to cut into the packaging or the cling film
because this might damage the contents.
Table 3-2. Required Tools and Equipment to Unpack the Battery Crate
Tool QTY Description
PPE N/A Eye protection, toe protection and gloves.
Table 3-3. Required Tools and Equipment to Unpack the Docking Target Crate
Tool QTY Description
PPE N/A Eye protection, toe protection and gloves.
13 mm socket
with impact
driver
1 The impact driver is used to remove side screws connecting the
housing crate to the base pallet.
Screwdriver, or
hammer
1 Screwdriver or hammer is used to remove the metal clips attaching
the front panel to the housing crate.
Table 3-4. Required Tools and Equipment to Unpack the Power Supply Box Crate
Tool QTY Description
PPE N/A Eye protection, toe protection and gloves.
Safety-rated
slings
4 The slings ship with the platform.
Forklift or similar
device
1 The forklift or any other lifting machine you use must be safety
rated for at least 1100 kg of weight.
14 mm socket
wrench
1 Socket wrench is used to unscrew the bolts connecting the power
supply box to the base pallet.
13 mm socket
with impact
driver
1 The impact driver is used to remove side screws connecting the
housing crate to the base pallet.
Screwdriver, or
hammer
1 Screwdriver, or the hammer is used to remove the metal clips
attaching the front panel to the housing crate.
31500-000 Rev A HD-1500 Platform User's Manual 64