Omron ZW Series - Page 104

3-26
Chapter 3 SETTINGS FOR FUNCTIONS
ZW
User’s Manual
Chapter 3
Setting the Output Conditions
As an example, here is an explanation of the procedure for selecting the "Span" setting
for the manual scaling type, and the "1.2" inclination coefficient setting.
Operating procedure
Steps Key operation Display Description
1 - 5 For moving to SCALE, see steps 1 to 5 in p.3-22
6 Select "Manual" as the scaling type.
The current setting value is displayed on the sub-
display.
Press / keys to enter the editing mode, and the
sub-display blinks.
Select "MANUAL" and press key.
7 Set "Span" as the manual scaling type.
Press or keys to select either of "SPAN" and
press key.
8 Set "1.2" in the inclination coefficient.
The current setting value is displayed on the sub-
display.
Press key to enter the editing mode, and the
sub-display blinks.
To edit numerical values use / / / keys.
Enter "500" and press key.
9 Press key for two seconds to enter the RUN
mode.
ZERORST/ZERORST/
ESCESC
ZERO/ZERO/
SETSET
ZERO/
ZERO/
SET
SET
ZERORST/ZERORST/
ESCESC
ZERO/ZERO/
SETSET
ZERO/
ZERO/
SET
SET
ZERORST/
ZERORST/
ESC
ESC
ZERO/
ZERO/
SET
SET
ZERO/
ZERO/
SET
SET
ZERO/
ZERO/
SET
SET
RUN
RUN
FUN
FUN
TEACH
TEACH
L
H L RUNRUN
LIT
RUN
RUN
FUN
FUN
TEACH
TEACH
L