Quantum ODYSSEY HF Series User Manual

Chapter 1 Specifications
Revision W HF Series X-ray Generators - Service Manual
1-14 Quantum Medical Imaging
Table 1-4. HF Series Generators -
Electrical Wiring Requirements (208-240 VAC Three-Phase Input Units)
QG-32-2
QG-40-2
QG-50-2
208
32
40
50
240
208
240
208
240
#6 AWG
#6 AWG
#4 AWG
#6 AWG
#4 AWG
#4 AWG
70 AMPS
60 AMPS
90 AMPS
70 AMPS
110 AMPS
90 AMPS
40 KVA
40 KVA
50 KVA
50 KVA
65 KVA
65 KVA
0.026 OHMS
0.023 OHMS
0.017 OHMS
0.024 OHMS
0.014 OHMS
0.016 OHMS
GENERATOR
MODEL NO.
MAX. POWER
OUTPUT (kW)
NOMINAL LINE
VOLTAGE (VAC)
DISCONNECT
TO GENERATOR
15 FT. (5 M) MAX.
*SERVICE
RATING
*RECOMMENDED
DISTRIBUTION
TRANSFORMER
CAPACITY
MAX. INPUT LINE
RESISTANCE
(AT FULL-LOAD
RMS)
QG-320,
QG-3200,
QGV-32-2
QG-400,
QG-4000,
QGV-40-2
QG-500,
QG-5000,
QGV-50-2
GENERATOR
CATALOG NO.
*NOTE: All installations must meet the requirements of local electrical codes.
The above values are recommended as typical (unless otherwise specified).
*
1.
Input Voltage: 208-257 (±5%) VAC 50/60 Hz (configured at time of installation)
. Voltage is three-phase Y-configuration, measured line-to-line, balanced to earth
ground. (Note: Additional Neutral wire may be used if required by local electrical code.)
Line Regulation: 5% at full load.
8. Ground wire size is 4 AWG.
9. Specifications are subject to change.
All wire must be copper.
2. Actual wire size depends on power quality and distance between mains power
and the generator.
3. All wiring and grounding must be in accordance with National
Electric Code (NFPA #70) or local electrical codes.
4. The disconnect switch must be located within reach of the operator.
5. .
6
7.

Quantum ODYSSEY HF Series Specifications

General

Brand	Quantum
Model	ODYSSEY HF Series
Category	Medical Equipment
Language	English