R&S FSPN - Page 465

Remote Control
R&S
®
FSPN
465User Manual 1179.4363.02 ─ 01
Manual operation: See " Predefined Colors " on page 224
HCOPy:CONTent <arg0>
This command determines the type of content included in the printout.
This setting is independent of the printing device.
Parameters:
<arg0> WINDows | HCOPy
WINDows
Includes only the selected windows in the printout. All currently
active windows for the current channel (or "MultiView") are avail-
able for selection. How many windows are printed on a each
page of the printout is defined by HCOPy:PAGE:WINDow<1|2>:
COUNt on page 471.
This option is not available when copying to the clipboard
(HCOP:DEST 'SYST:COMM:CLIP' or an image file (see
HCOPy:DEVice:LANGuage<1|2> on page 467).
If the destination is currently set to an image file or the clipboard,
it is automatically changed to be a PDF file for the currently
selected printing device.
HCOPy
Selects all measurement results displayed on the screen for the
current channel (or "MultiView"): diagrams, traces, markers,
marker lists, limit lines, etc., including the channel bar and status
bar, for printout on a single page. Displayed items belonging to
the software user interface (e.g. softkeys) are not included. The
size and position of the elements in the printout is identical to the
screen display.
*RST:
HCOPy
Example:
HCOP:DEST1 'SYST:COMM:CLIP'
HCOP:CONT WIND
HCOP:DEST1?
//Result: 'MMEM'
HCOP:DEV:LANG1?
//Result: 'PDF'
"Print to clipboard" is automatically switched to "print to PDF file"
when the contents are switched to "multiple windows".
Manual operation: See " Print Screenshot " on page 199
See " Print Multiple Windows " on page 199
HCOPy:DESTination<1|2> <arg0>
This command selects the destination of a print job.
Note: To print a screenshot to a file, see HCOPy:DEVice:LANGuage<1|2>
on page 467.
Managing Settings and Results