R&S TSMA6 - Create an R&S TSMA6 Image Stick

Installing firmware and software updates
R&S
®
TSMA6
115User Manual 4900.8057.02 ─ 11
● Create an R&S TSMA6 image stick...................................................................... 115
● Boot from the R&S TSMA6 image stick................................................................ 116
● Capture an image from an R&S TSMA6............................................................... 116
● Apply an image to an R&S TSMA6....................................................................... 118
8.7.1 Create an R&S TSMA6 image stick
You need administrator rights on the PC, where you create the image stick.
To create an R&S TSMA6 image stick, proceed as follows.
Prerequisites:
●
A bootable USB stick (USB 3.1 Gen1) with a capacity of at least 64 GB. Make sure
that the data on the USB stick is no longer needed as it will be formatted during
process of R&S TSMA6 image stick creation.
●
Download the "R&S TSMA6 Image Stick" (TSMA6_ImageStick-v<x.y>.zip)
tool (www.rohde-schwarz.com/software/tsma6).
●
On a PC, unzip the file TSMA6_ImageStick-v<x.y>.zip to a directory of your
own choice. The extracted directory contains the PrepareWinPEStick.exe file.
1. Insert the USB stick into a free USB3.1 port of a PC.
2. Execute the PrepareWinPEStick.exe file in the directory, where you have
saved the file.
3. Select the USB stick via the "Removable Device Selection" drop-down box.
4. Press "Create RecoveryStick".
In the main directory of the image stick, following directories and files are created auto-
matically:
●
/Boot
●
/Device
●
/EFI
●
/sources
●
bootmgr
Capture and apply R&S TSMA6 images