R&S TSMA6 - General Workflows; R&S NESTOR Based Workflow

General workflows
R&S
®
TSMA6
40User Manual 4900.8057.02 ─ 11
5 General workflows
Prerequisites
●
Antennas connected (RF, GPS)
●
Software license available. With WiBu following solutions are possible.
– Wibu dongle
– Wibu software license - requires no dongle
●
Power supply connected (DC/AC/Battery Pack) and TSMA6B switched on
●
LAN/WLAN connection to host PC established
– LAN
Connect the R&S TSMA6 LAN socket with an RJ45 cable to the LAN. By
default the R&S TSMA6 is configured to use DHCP and no static IP address is
set. The R&S TSMA6 shows the IP address in the local web-GUI.
Start a web browser on the remote device and enter the following URL:
http://TSMA6-<xxxxxx>.local (xxxxxx is the serial number of this specific R&S
TSMA6) or use the IP displayed from the local web-GUI.
– WLAN (see Chapter 3.1.9, "Connecting with R&S TSMA6 WLAN access point",
on page 26)
Default WLAN-Access point
SSID: TSMA6-xxxxxx (xxxxxx is the serial number of this specific R&S TSMA6)
Default key: instrument
●
License Keys installed
– Scanner
– Software
– QualiPoc mobile
●
Optional: mouse, keyboard and monitor for local control
●
Optional: Additional cabeling for R&S TSME6 and R&S TSMExxDC connection
– LAN cable: TSME6 "LAN" connector <-> TSMA6B "SCAN" connector
– AUX cable: TSME6 "AUX" connector <-> TSMA6B "AUX" connector
– Power cable: TSME6 "DC IN" connector <-> Power Supply
See Chapter 7.2, "Use cases", on page 76.
●
Optional: USB2LAN converter (TSPC-U2Lx)
Connect TSPC-USL2 / TSPC-U2L to to blue USB3.0 port
5.1 R&S NESTOR based workflow
* For details about the prerequisites, see "Prerequisites" on page 40.
R&S NESTOR based workflow