Getting started
R&S
®
TSMA6
29User Manual 4900.8057.02 ─ 11
2. Configure the LAN port IP address settings in the R&S TSMA6 web-GUI (see
Chapter A.2.2.4, "LAN", on page 163) in accordance with your administrator guide-
lines:
a) Local configuration, see Chapter 6.1.1.1, "Using the web GUI locally",
on page 43.
b) Remote configuration, see Chapter 6.1.1.2, "Using WLAN from a remote PC or
smartphone", on page 44
3. Alternatively, use the assigned IP address for remote access (see Chapter A.1.2,
"IP settings", on page 154).
The default IP setting is "DHCP" (configure IP address automatically). The assigned IP
address for remote access when using DHCP is displayed in the web-GUI (see Chap-
ter A.1.2, "IP settings", on page 154').
3.1.11 Connecting USB to LAN adapter (optional)
To extend the available number of Gbit LAN ports, various optional USB to LAN adapt-
ers are available:
●
R&S TSPC-U2L (Single Gbit LAN port adapter)
●
R&S TSPC-U2L2 (Dual Gbit LAN port adapter )
●
R&S TSPC-U2L4 (USB-C to 4-port Ethernet)
For R&S TSPC-U2L4, no driver needs to be loaded. The firmware automatically config-
ures the port (see Chapter A.2.2.6, "LAN EXT2 / EXT3 / EXT5 / EXT6", on page 165).
For R& TSPC-U2L and R&S TSPCU2L2, check if driver updates are required.
For information how to connect an additional adapter, see https://www.rohde-
schwarz.com/driver/tsma6/.
3.1.12 Connecting test mobile phones (optional)
When you connect a test mobile phone to a USB port for the first time, the installation
of the appropriate drivers is mandatory.
Currently following driver is available.
●
Samsung USB driver
For information how to connect Qualcomm based mobiles and required driver updates,
see https://www.rohde-schwarz.com/driver/tsma6/.
To connect test mobile phones
► Connect test mobile phones to USB 3.0 / USB-C ports (see Figure 3-7 - 2, 14).
Preparing for use
To Next Page
Loading...
Need help?
General
