R&S TSMA6 - SmartONE Remote Installation

Installing firmware and software updates
R&S
®
TSMA6
111User Manual 4900.8057.02 ─ 11
All subsequent steps are similar to remote firmware installation, see Chapter 8.3.2,
"Remote installation of the setup file", on page 88, step 5 and following.
8.6.3.4 Initial software start / measurement mode selection
After the successful installation of R&S SmartONE, the device always is in "QualiPoc"
mode.
Initial starting of SmartONE Expert (R&S ROMES)
1. Start the web GUI.
2. Navigate to "Configuration" > "System" > "Mode".
3. As "Mode of Operation" select "SmartONE Expert".
Make sure, that "Autostart" is deselected and no workspace is selected.
Software update - details