EasyManuals Logo

R&S TSMA6 User Manual

R&S TSMA6
190 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #158 background imageLoading...
Page #158 background image
Web GUI reference
R&S
®
TSMA6
158User Manual 4900.8057.02 ─ 11
A.2.1.1 Mode
The "Mode" tab is used to configure and read back the selected mode of operation.
Mode of Operation...................................................................................................... 158
Current Measurement................................................................................................. 158
Mode of Operation
Set of radio buttons for all supported modes of operation. The desired measurement
mode is selected and activated by pressing "Submit". The selected mode is automati-
cally started after each power up as long as not reconfigured by the user.
In "PC Mode", no active measurement is selected in autostart.
Current Measurement
Status information and action buttons for the selected mode of operation.
A.2.1.2 Power
The "Power" tab displays all settings related to the power on/power off scenarios.
Startup Settings...........................................................................................................158
Auto Power ON.............................................................................................158
Remember Last State...................................................................................158
Delayed System Start................................................................................................. 158
Sleep Mode Settings...................................................................................................158
Battery.........................................................................................................................159
Shutdown Settings...................................................................................................... 159
Auto Power Off..............................................................................................159
Startup Settings
Configures different startup sequences.
Auto Power ON ← Startup Settings
The device is starting automatically when DC power is available at the DC IN connec-
tor or at the docking connector for the battery pack unit.
Remember Last State ← Startup Settings
When the device was powered down in the previous measurement session, then the
device will keep this state when DC power is applied again.
Delayed System Start
Note: To support this mode, connect a R&S TSMA6 battery pack.
The delay time is configured at the R&S TSMA6x. After pressing "Activate" and "Shut-
down", the device enters sleep mode and starts after the configured delay. The sleep
mode is indicated with a green blinking "Mode" LED.
Sleep Mode Settings
Note: To support this mode, connect a R&S TSMA6 battery pack.
If activated, the device enters sleep mode after power down. The CPU LAN port
remains powered to access the device via Intel ATM.
Configuration

Table of Contents

Other manuals for R&S TSMA6

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the R&S TSMA6 and is the answer not in the manual?

R&S TSMA6 Specifications

General IconGeneral
BrandR&S
ModelTSMA6
CategoryScanner
LanguageEnglish

Related product manuals