Troubleshooting
R&S
®
TSMA6
131User Manual 4900.8057.02 ─ 11
Label Description
Valid From Start of validity for temporary license
Valid To End of validity for temporary license
Time to Expiration Time left until license expires
Option Index for internal use only
Format ID for internal use only
11.6 R&S TSMA6 automatically switches off after power on
1. Check if there is a battery pack unit connected.
● If yes, continue with step 2.
● If no, contact R&S support.
2. Check the state of charge of the batteries.
● If the charging state is > 20% (charging indicator displays one loading bar),
continue with step 4.
● If the charging state is < 20%, an auto power off of the device is performed due
to insufficient remaining battery charge. Continue with step 3
3. Perform one of the following actions.
a) Replace the batteries with fully charged ones and try again.
b) Charge the batteries in an external charger and retry later.
c) Connect DC supply to the R&S TSMA6 battery pack unit and charge the batter-
ies inside the bay. Keep the R&S TSMA6 switched off.
4. Connect DC supply to the R&S TSMA6 battery pack unit and check in the web GUI
the "Shutdown Settings".
Navigate to "Configuration" > "System" > "Power" and check the state of "Auto
Power Off".
● If enabled, check the shutdown delay.
● If not enabled, contact R&S support.
R&S TSMA6 automatically switches off after power on
To Next Page
Loading...
Need help?
General
