R&S TSMA6 - Verify LAN Settings (Internal Scanner Connection)

Troubleshooting
R&S
®
TSMA6
135User Manual 4900.8057.02 ─ 11
7. Check in the "Info" tab, if any device is available.
● If the R&S TSMA6 device is found, check the "Device Analysis Output".
● If the R&S TSMA6 device is not found, contact the R&S support.
8. Check the "Device Analysis Output".
● If there is an error, check if autofix is possible.
If autofix is possible => continue with step 9.
If autofix is not possible => contact R&S support.
● If there is no error, continue with step 9
9. Check the "Options" tab (see Figure 11-2).
● If all required options are active, the scanner works correctly.
● If necessary options are missing, contact R&S support.
11.8 Verify LAN settings (internal scanner connection)
1. Check the IP setting of the TSMA6 scanner connection.
Navigate to "Windows" > "Settings" > "Network & Internet" > "Network & Sharing
Center" > "Change Adapter Options".
The entry "TSMA6 Scanner Connection Int" must be available.
Verify LAN settings (internal scanner connection)