R&S TSMA6 User Manual

User backup and restore
R&S
®
TSMA6
123User Manual 4900.8057.02 ─ 11
Loss of user settings after restore
Executing restore brings the R&S TSMA6 irreversible back to the condition of delivery
or any other subsequently stored user backup version.
On the C:\ drive, all user settings and installed programs since the last backup will be
deleted.
The D:\ partition is deleted if enabled in the web-GUI, see "Delete Data partition D:"
on page 168.
Table 10-2: Restore conditions
Initiate Restore /
Available Partitions
Restore button Restore button Restore factory backup
(see Chapter 10.3,
"Restore factory
backup", on page 123)
Factory Backup X X X
User Backup (see Chap-
ter 10.1, "User backup",
on page 122)
no user backup
(factory default)
X X
Condition after restore
Partition C:\ C:\factory backup C:\user backup C:\factory backup
Partition D:\ (default) unchanged unchanged unchanged
Partition D:\
(web-GUI setting "Delete
Data partition D:"
on page 168)
deleted deleted deleted
When the restore procedure has been completed, the color of the [Mode] LED
depends on the state of the WLAN AP (see Table 10-3).
Table 10-3: LED states (Restore)
[Mode] LED Status
blue blinking Restore process running
green Restore process finished, WLAN AP off
blue Restore process finished, WLAN AP on
10.3 Restore factory backup
To restore the factory backup, perform the following steps.
1. Connect mouse, keyboard and monitor to the R&S TSMA6.
2. Press the [Shift] key and reboot the operating system.
3. The R&S TSMA6 reboots in the R&S recovery environment.
Restore factory backup

R&S TSMA6 Specifications

General

Brand	R&S
Model	TSMA6
Category	Scanner
Language	English