R&S TSMA6 - Switching On or Off R&S TSMA6

Getting started
R&S
®
TSMA6
25User Manual 4900.8057.02 ─ 11
Figure 3-4: Connected R&S TSMA6/6B and R&S TSMA6-BP
1 = Attach R&S TSMA6 to R&S TSMA6-BP
2 = Move R&S TSMA6/6B to the rear side
3 = Power connection established (docking connector is snapped in)
3.1.8 Switching on or off R&S TSMA6
To switch on the device
The device is off but connected to power.
► Press the power on/off button.
The Pwr LED starts green blinking. After booting, the color changes to green resp.
blue continuous depending on the state of the WLAN access point (see Chap-
ter 3.2.5, "Status LEDs", on page 35).
To shut down the device
► Press the power on/off button.
The Pwr LED starts blinking green. The operating system shuts down and the Pwr
LED is switched off.
Preparing for use