R&S TSMA6 - R&S TSMA6 with R&S TSME6 and R&S TSMA6-BP

Measurement Setup
R&S
®
TSMA6
77User Manual 4900.8057.02 ─ 11
7.2.1 R&S TSMA6 with R&S TSME6 and R&S TSMA6-BP
Figure 7-17: R&S TSMA6 + R&S TSME6
1 = LAN connection: R&S TSMA6 (SCAN port) - R&S TSME6
2 = Synchronization: R&S TSMA6 - R&S TSME6
3 = DC power: R&S TSMA6-BP - R&S TSME6
4 = RF: R&S TSMA6 RF In < 6 GHz
5 = RF: R&S TSME6
For the LAN connection between R&S TSMA6 and R&S TSME6, you need LAN cable
of type CAT6.
Change the SCAN port of the R&S TSMA6 via the web-GUI to DHCP (see "TCP/IP
Mode (LAN SCAN)" on page 164). This allows to connect aE6 without IP address
change.
For the synchronization between R&S TSMA6 and R&S TSME6, you need the syn-
chronization cable R&S TSME6-ZC2.
For the DC power between R&S TSMA6-BP and R&S TSME6, you need the power
cable R&S TSMA6-BPPT.
For the RF input connector, you need an antenna according to your needs.
Use cases