Getting started
R&S
®
TSMA6
19User Manual 4900.8057.02 ─ 11
3 Getting started
3.1 Preparing for use
Here, you can find basic information about setting up the product for the first time.
3.1.1 Unpacking and checking
1. Unpack the product carefully.
2. Retain the original packing material. Use it when transporting or shipping the prod-
uct later.
3. Using the delivery notes, check the equipment for completeness.
4. Check the equipment for damage.
If the delivery is incomplete or equipment is damaged, contact Rohde & Schwarz.
3.1.2 Preparing for outdoor usage
If you want to perform a walk test, the R&S TSMA6 needs weather protection because
the product casing is not waterproof. The R&S TSMA6-ZCB2 carrying bag is especially
designed for this purpose. See also "Operating the product" on page 12.
3.1.3 Setting up indoors
3.1.3.1 Placing the product on a bench top
If you want to set up the R&S TSMA6 on a benchtop or prepare the R&S TSMA6 for
mobile use, proceed as follows.
To place the product on a bench top
1. Place the R&S TSMA6 on a stable, flat and level surface.
2. If you want to stack R&S TSMx products, proceed as described in Chapter 7.1,
"Vibration-proofed stacking", on page 63.
3. If you want to stack the R&S TSMA6 together with other products:
a) Follow the instructions given for the other products.
b) Place the R&S TSMA6 on top.
Preparing for use
To Next Page
Loading...
Need help?
General
