Configuring the R&S TSMA6
R&S
®
TSMA6
55User Manual 4900.8057.02 ─ 11
2. Configure the additional settings for "SmartONE Expert" mode only.
● Autostart
R&S SmartONE Expert is automatically started in this mode with a workspace
file. The workspace file need to be selected via the drop-down menu.
● Workspace File
In "Autostart" mode, select via the drop-down menu a workspace file (see
"Import of SmartONE Expert workspace file" on page 56).
● Recording
Activating this checkbox, the SmartONE measurement data are written to the
TSMA6 hard disk.
● IP Controlled
Activating this checkbox, you can control the SmartONE measurement via IP
from an external host PC. No "Autostart", "Workspace File" and "Recording"
setting is needed in this mode.
3. Click "Submit" (3) activate the selected measurement configuration.
For more details about the R&S SmartONE configuration and usage, refer to the user
documentation for R&S SmartONE.
6.5 Importing workspace files (NESTOR, SmartONE
Expert)
Import NESTOR workspace file
1. Start the R&S TSMA6 web GUI from the host PC (see Chapter 6.1.1, "Using the
R&S TSMA6 web GUI", on page 43).
2. Navigate to "Configuration" > "System" > "Mode" and set measurement mode to
"NESTOR Probe".
3. Press "Submit" and wait until the device is in "NESTOR Probe" mode. (The status
bar displays "No error".)
4. Navigate to "File Transfer" and press the "Browse..." button in the "Upload" section.
5. Search on the host PC for the NESTOR workspace file to be imported and confirm
the dialog with "Open".
6. Press "Upload".
The file is copied to the NESTOR workspace directory (default:
D:\Users\Instrument\Documents\NESTOR\FavoriteWorkspaces).
This path can be configured in the "File Transfer" menu.
7. Navigate back to "Configuration" > "System" > "Mode".
8. The imported workspace file is selectable from the list box in the "Mode" tab.
Importing workspace files (NESTOR, SmartONE Expert)
To Next Page
Loading...
Need help?
General
