To Next Page

To Previous Page

Configuring the R&S TSMA6

R&S

TSMA6

56User Manual 4900.8057.02 ─ 11

Import of SmartONE Expert workspace file

Importing of the R&S SmartONE Expert workspace file is an additional requirement for

operating in the "SmartONE Expert" mode.

1. Start the R&S TSMA6 web GUI (see Chapter 6.1.1, "Using the R&S TSMA6 web

GUI", on page 43).

2. Navigate to "File Transfer" menu and go to section "Upload File to TSMA".

3. Press the "Browse" button, select the desired ROMES workspace file on the

remote PC and click "Upload File".

4. The file is copied by default in the directory

C:\ProgramData\Rohde&Schwarz\My ROMES\Workspace.

Note: The target directory for file upload depends on the selected mode. The men-

tioned directory is only valid in ROMES mode.

6.6

Pairing Bluetooth

devices

To pair the R&S TSMA6 with a remote device, the following steps must be performed.

For Bluetooth

preparation, the device must be in the "PC Mode". Check it via the web

GUI ("Home" > "Overview").

To change the operation mode, navigate to "Configuration" > "System" > "Mode" and

select an operation mode.

In the web-GUI, verify the Bluetooth

settings on R&S TSMA6.

Figure 6-6: Bluetooth settings

2. Navigate to "Configuration" > "Connectivity" > "Bluetooth" and verify the settings:

Pairing Bluetooth

devices

R&S TSMA6 User Manual

Other manuals for R&S TSMA6