Configuring the R&S TSMA6
R&S
®
TSMA6
54User Manual 4900.8057.02 ─ 11
For more details about the R&S NESTOR configuration and usage, refer to the user
documentation for R&S NESTOR.
6.4.1.5 SmartONE mode
The SmartONE modes are only displayed if SmartONE software is installed (see
Chapter 8.6.3, "R&S SmartONE setup (SmartBenchmarker, ROMES, QualiPoc)",
on page 109).
To use the R&S TSMA6 with R&S SmartONE, the following steps must be performed.
1. In the web GUI, set the "Mode of Operation" to one of the following SmartONE
modes and press "Submit".
● "SmartONE Standard" (1)
Activating this mode, a web-based UI with the SmartBenchmarker application
software, designed for efficient data collection and remote control support in
combination with SmartMonitor can be used.
● "SmartONE Expert" (1)
Activating this mode, an expert UI with the ROMES4 application software for
complex measurement tasks and detailed data investigation during the mea-
surement can be used.
For the initial settings after installation, see Chapter 8.6.3.4, "Initial software
start / measurement mode selection", on page 111.
● "Smart Monitor" (2)
Activating this mode, a central, web-based module for controlling and monitor-
ing a fleet of QualiPoc android probes can be used.
Selecting measurement mode
To Next Page
Loading...
Need help?
General
