R&S TSMA6 User Manual

Configuring the R&S TSMA6
R&S
®
TSMA6
49User Manual 4900.8057.02 ─ 11
This mode starts the Remote ViCom server on the R&S TSMA6. Measurement config-
uration and data collection are controlled from a remotely connected handheld device.
Install a Remote ViCom client application on the handheld device for this purpose.
The connection between the Remote ViCom server on the R&S TSMA6 and the client
application (Remote ViCom client) on the handheld device can be realized via Blue-
tooth
®
or WLAN.
The selection of the wireless interface type depends on the measurement task.
The WLAN connection allows a data throughput, which is about 10 times higher com-
pared to Bluetooth
®
.
The Bluetooth
®
connection is less influenced by radio interference.
Prerequisites
●
Bluetooth connection only
See Chapter 6.6, "Pairing Bluetooth
®
devices", on page 56.
●
WLAN connection only
Connect the tablet/smartphone with the R&S TSMA6 WLAN AP. See Chap-
ter 3.1.9, "Connecting with R&S TSMA6 WLAN access point", on page 26.
Measurement with the rViCom sample App
To run measurements, the requirements for operating the rViCom sample App have to
be fulfilled, see Chapter B, "Introduction to Remote ViCom Sample App", on page 170.
1. Activate the rViCom server mode (see Chapter 6.4, "Selecting measurement
mode", on page 47).
2. Start one of the following applications.
a) Start the OEM rViCom client application on the mobile device.
b) Start the rViCom sample App on the mobile device.
For more details, see Chapter B.3, "Usage", on page 171.
6.4.1.3 QualiPoc mode
The QualiPoc mode selector is only displayed if the R&S SmartONE software is instal-
led (see Chapter 8.6.3, "R&S SmartONE setup (SmartBenchmarker, ROMES, Quali-
Poc)", on page 109).
Prerequisites
●
The appropriate scanner license must be installed on the QualiPoc
®
handheld
device. If you do not have the correct license, contact the R&S service.
●
On the R&S TSMA6, Bluetooth
®
must be activated and visible (see Figure 6-6).
To use the R&S TSMA6 with QualiPoc
®
, the following steps must be performed.
Selecting measurement mode

R&S TSMA6 Specifications

General

Brand	R&S
Model	TSMA6
Category	Scanner
Language	English