Installing firmware and software updates
R&S
®
TSMA6
91User Manual 4900.8057.02 ─ 11
10. Select "Install".
Note: Do not switch off or unplug from power while running firmware/software
update.
11. The state of the installation process is displayed in the "Status" column. The proc-
ess is finished when the status indicates "Ready, see report for details!".
Note: If you are connected via WLAN, a reconnect to the R&S TSMA6 WLAN
access point may be necessary as the R&S TSMA6 reboots after the firmware/soft-
ware update.
12. Select "Exit" to end the setup program on the remote PC.
13. Only for firmware update.
If the firmware package contains a new mainboard firmware, a separate flash rou-
tine is started in a post process, see Chapter 8.3.5, "Subsequent steps after firm-
ware update", on page 96.
Note: If you are connected via WLAN, a reconnect to the R&S TSMA6 WLAN
access point may be necessary as the R&S TSMA6 reboots after the firmware/soft-
ware update.
14. Reload the R&S TSMA6 web GUI (see Chapter 8.3.4, "Calling R&S TSMA6 web
GUI", on page 95) and verify the installed firmware /software version in the "Over-
view".
15. The firmware/software update is completed successfully and the device is ready for
operation when the firmware / software is listed correctly in the "Overview" page of
the R&S TSMA6 web-GUI.
Updating firmware/software/tools - general instructions
To Next Page
Loading...
