Installing firmware and software updates
R&S
®
TSMA6
94User Manual 4900.8057.02 ─ 11
Note: Do not switch off or unplug from power while running firmware/software
update.
11. Once the installation of all firmware/software packages has finished, the R&S
TSMA6 reboots.
After reboot the firmware is running a selftest (Mode LED is blinking green).
Note: If you are connected via WLAN, a reconnect to the R&S TSMA6 WLAN
access point may be necessary.
12. Open the web GUI. After a while, the status text in the web GUI changes to
No error.
The reboot is finished when the Mode LED changes into steady blue (WLAN AP
On) or green (WLAN AP Off) color.
13. Only for firmware installation.
If the firmware package contains a new mainboard firmware, a separate flash rou-
tine is started in a post process, see Chapter 8.3.5, "Subsequent steps after firm-
ware update", on page 96.
Note: If you are connected via WLAN, a reconnect to the R&S TSMA6 WLAN
access point may be necessary as the TSMAx reboots after the mainboard flash.
14. Reload the R&S TSMA6 web GUI (see Chapter 8.3.4, "Calling R&S TSMA6 web
GUI", on page 95) and verify the installed firmware /software version in the "Over-
view".
Updating firmware/software/tools - general instructions
To Next Page
Loading...
Need help?
General
