Rexroth IndraDrive Replacing Devices 16-3
DOK-INDRV*-SYSTEM*****-PR02-EN-P
Replacing Cables
WARNING
Lethal electric shock caused by live parts with
more than 50 V!
⇒
Power connectors of the cables may only be
separated or connected if the installation has been
de-energized!
Note: When replacing cables, observe the instructions of the
machine manufacturer.
If you do not use ready-made Rexroth cables, check to ensure
that the cables match the terminal diagram of the machine
manufacturer!
• open main switch
• make sure main switch cannot be switched on again
• disconnect plug-in connectors
Note: When replacing cables, cover the open mating sites of power
lines with protective caps if sprinkling with cooling
liquid/lubricant or soiling may occur (allowed degree of soiling
according to EN50178: 2).
• replace cable
CAUTION
Property damage caused by bad power
connectors!
⇒
Only separate or connect clean and dry power
connectors.
• connect plug-in connectors
To Next Page
Loading...
