Ricoh PRO C7210

1.SC Codes
173
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC725-13
B
Dynamic Roller Transport Motor Error
 Motor driver detected an error. (SC from the first time)
 Overcurrent to the motor.
 Motor drive overheat
 Replace the Main Board.
 Replace the Dynamic Roller Transport Motor
 Replace the harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC725-14
B
Top Tray Exit Motor Error
 Motor driver detected an error. (SC from the first time)
 Overcurrent to the motor.
 Motor drive overheat
 Replace the Main Board.
 Replace the Top Tray Exit Motor.
 Replace the harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC725-
30
B
Stopper 1 Motor Error
 When moving to the home position, home position was not detected within
specified number of pulses. (The first time: jam display, the second time: SC)
 When moving from the home position, home position was still detected after
specified number of pulses. (The first time: jam display, the second time: SC)
 Motor driver detected an error. (SC from the first time)
 Overcurrent to the motor.
 Motor drive overheat
 Connector disconnected
 Replace the Main Board.
 Replace the Stopper 1 Motor.
 Replace the harness.
 Reconnect the connector.
 Replace the Stopper 1 HP Sensor
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC725-
31
B
Stopper 2 Motor Error
 When moving to the home position, home position was not detected within