Rohde & Schwarz R&S SGS100A - Page 139

Signal generator settings
R&S
®
SGS100A
139User Manual 1173.9105.02 ─ 13
:EXTension:INSTruments:SCAN[:STATe] on page 232
:EXTension:REMote:STATe? on page 231
Scan
Triggers a scan function and searches for instruments connected to the instrument via
all the available interfaces.
Remote command:
:EXTension:INSTruments:SCAN[:STATe] on page 232
Test Signal Connections
The "Test" function triggers a test of all signal connections between the instrument and
the extension. The schematic diagram displays the required physical signal connection
for the current test setup and the connection state.
A faulty connection is marked with a red line crossing the drawn blue connection line
as shown in Figure 9-10. If your connection is marked as faulty check whether the
cables are connected properly and if the connection cables are functioning properly.
Figure 9-10: A faulty connection between an R&S SGU and an R&S SGS
Note:
If your connection is marked as faulty check whether the cables are connected
properly. Check also if the connection cables are functioning properly.
Remote command:
:TEST:EXTension:CONNection? on page 234
:TEST:EXTension:CONNection:RF? on page 234
Extension