Rotax 125 MAX evo Repair Manual

BRP-Rotax
REPAIR MANUAL
7. Clean the drive end crankshaft web hole with cleaning agent (grease-free).
8. Coat the hole with LOCTITE 648.
NNOOTTEE
Remove excess LOCTITE, otherwise the con rod may be damaged.
Figure 5.19
1
Crankshaft half (engine end)
2
Bottom section of the repair jig
3
Con rod pin
4 Con rod
______________________________________________________
9. Slide the drive-end crankshaft half (1) into the top section of the repair jig (2).
10. Hold the crankshaft half as shown in following Figure and push the top section of the tool (3)
into the bottom section of the tool (2).
NNOOTTEE
A rotary movement of the con rod makes it easy to align the web hole with the con
rod pin.
11. Position the thrust ring (4) on the top section of the repair jig and press the two crankshaft
halves together (until the crankshaft pin is aligned with the crankshaft web).
Chapter 5
Page 24
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
Edition - February 01 2018 /Rev. 0

Rotax 125 MAX evo Specifications

General

Brand	Rotax
Model	125 MAX evo
Category	Engine
Language	English