BRP-Rotax
REPAIR MANUAL
Figure 5.26: Oil seal installation
1 Oil seal AS 28x38x7 2
Mounting tool part no. 676010
______________________________________________________
Instruction See Figure: Ball bearing.
5. Slide the ball bearing (1) of the crankshaft into the crankcase half to the limit stop so the
closed side of the cage is facing to the crankshaft.
NNOOTTEE
The labeling of the ball bearing must be visible!
6. Slide the ball bearing (2) of the balance shaft into the crankcase half to the limit stop so the
closed side of the cage is facing to the balance shaft.
Figure 5.27: Ball bearing
1
Ball bearing 6206
2
Ball bearing 6302
______________________________________________________
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
Edition - February 01 2018 /Rev. 0
Chapter 5
Page 31
To Next Page
Loading...
