When to Replace Media
216
(1) Print head position
(2) Paper end sensor: I-mark sensor/Gap sensor
Select in [Printing] > [Advanced] > [Paper End] menu, or specify by command.
(3) Media feed direction
If a paper end error is detected while printing, operation varies depending on the amounts of printing
and media remaining when the error was detected.
The amount of media remaining can be calculated as follows:
Amount of media remaining = distance between print head position and paper end sensor -15 mm
(-0.59")
(1) Print head position
(2) Distance between the print head position and paper end sensor
(3) Paper end sensor
(4) Amount of media remaining
• When the Amount of Printing Remaining Is More Than the Amount of Media Remaining
If the amount of printing remaining is more than the amount of media remaining when a paper
end error is detected, the printer cannot finish the print job. Printing stops immediately and a
paper end error occurs.
(1) Print head position
(2) Paper end sensor
(3) Amount of media remaining
(4) Amount of printing remaining
To Next Page
Loading...
