[Print Mode]
224
The setting range is from 0 to 999 dots.
(1) Media feed direction
(2) I-mark position
(3) Print position
• The length of 1 dot is 0.083 mm (0.0033").
• You can change the unit to dots or inches in the [System] > [Regional] > [Unit] menu.
[Auto-mode]
When [Auto-mode] is enabled, the print mode changes automatically according to the status of the
installed option or the way media is loaded.
• With the standard model, operate in dispenser mode if you have loaded media for
dispenser mode and tear-off mode if you have loaded media for continuous/tear-off
mode.
• Operate in cutter mode if you have installed the optional cutter kit.
• Operate in partial cutter mode if you have installed the optional partial cutter kit.
[Print Mode]
Set the print mode.
The options are as follows:
Continuous
Continuously print the specified number of the media. The media remains in position for printing at
all times.
Tear-Off
After printing the specified number of media, the printer feeds the last printed media so that it is
fully extended out of the printer’s front for removal. After printing, tear off the media manually. The
media will be back to the print head position for starting the next printing.
Linerless tearoff
The printer feeds each printed media so that it is fully extended out of the printer’s front for
removal. After the printed media is torn off manually, the next media retracts and positions itself
for printing. When using a linerless label, install the optional linerless kit and select [Linerless
tearoff] instead of [Tear-Off].
To Next Page
Loading...
Need help?
General
Weight and Dimensions
