SATO FX3-LX - [Sdpl]

273
[SDPL]
To use SDPL as a printer command, set the following items:
• [Format Attribute], [Pause Mode], [1 Byte Codepage], [SDPL Measure Unit] and
[Scalable Font Style] are available only if [Settings] is selected for the corresponding
setting item in the [Prioritize] menu.
[Control Code]
Set the control code.
The setting items are as follows:
[Code Type]
Set the type of the control code.
The options are as follows:
• [Standard]
• [Alternate 1]
• [Alternate 2]
• [Custom]
[SOH]
Set the SOH code.
You can change the code only if you have selected [Custom] in the [Code Type] menu.
The setting range is from 0 to ff (hexadecimal).
[STX]
Set the STX code.
You can change the code only if you have selected [Custom] in the [Code Type] menu.
The setting range is from 0 to ff (hexadecimal).
[CR]
Set the CR code.
You can change the code only if you have selected [Custom] in the [Code Type] menu.
The setting range is from 0 to ff (hexadecimal).
[CNTBY]
Set the CNTBY code.
You can change the code only if you have selected [Custom] in the [Code Type] menu.
The setting range is from 0 to ff (hexadecimal).
[Label Rotation]
Set the page orientation for label printing.