SATO FX3-LX - LAN Interface Connection (USB+LAN Model Only); Wireless LAN Interface Connection (Optional)

143
• If it does not communicate well, shift the Android device to the front, back, left and
right, and then hold it up again.
• For the operation of the NFC for the Android device, refer to the user manual for the
Android device.
LAN Interface Connection (USB+LAN Model Only)
Connect the interface cable when the printer is powered off.
Connect the LAN cable to the LAN connector (1) of the printer.
The communication condition settings must be configured according to your network environment. Set
the IP address of the printer.
The IP address of the printer can be set through the printer's [Interface] menu or the All-In-One Tool.
• To use the printer driver, the communication protocol must be set to Status4. (The
initial value of the communication protocol for the printer's LAN interface is Status4
ENQ.)
Wireless LAN Interface Connection (Optional)
Check if the wireless LAN/Bluetooth kit (1) is attached to the printer.